Information about using your gas cylinder and balloons:

• Attach regulator by screwing securely to the main cylinder.
• Turn the tap handle to release the gas and you will hear the regulator fill up.
• Take a balloon and cover the black rubber end with the neck of the balloon.
• Compress the handle to release the gas and fill the balloon being careful not to exceed the capacity of the balloon.
• Release the handle and tie balloon in a knot or insert valve.
• Remember to close the gas tap before taking off the regulator or it will not come out.
• Please look after the regulator as it is a delicate piece of equipment and can be easily broken.

3 cylinder sizes

the regulator

the regulator in place

Some Do's & Don'ts:

• When not in use, DO store the cylinder upright in a well ventilated area, away from any source of heat e.g. gas fire, radiator.
• If transporting the cylinder, DO secure it (so it will not roll around, that the valve cannot be accidentally knocked open) and allow adequate ventilation.
• DO turn off gas and disconnect filling adaptor when not in use.
• DO waer safety eye protection when inflating balloons.
• DO keep children away from cylinder.
• DO consyult a Doctor in case of an emergency.
• DO please ring our office if unsure about any of the above: 0800 074 0387.

• DO NOT inhale Helium Gas. It is an asphyxiant gas. In large quantity it can cause unconsciousness. Death is also a possibility.
• DO NOT open the cylinder valve without the adaptor attached to it. The cylinder is highly pressurised.
• DO NOT insert rice or similar particles in the Ballloon. (Can cause eye injury).
• Children under the age of three, should not be allowed to play with Ballloons. (Burst or uninflated balloons can cause choking if swallowed).
• DO NOT use a spanner. To connect, firmly screw the adaptor to the cylinder by hand and gently open valve.

• DO please ring our office if unsure about any of the above: 0800 074 0387.